Veteran Garage Door Repair | Keller TX | 817-769-8488

Garage Door Opener Repair

You might discover that your garage door opener has been offering you problems, so you need to repair it. You can fix it by changing a circuit card, a photo-eye sensing unit, the main drive gear, or the set-limit buttons. You can additionally check if the security sensors are functioning appropriately.

Changing a motherboard

Changing a motherboard for your garage door opener requires a few actions and devices. First, you need to switch off the breaker and disconnect any cables. Next off, open up the circuit board cover. This will assist you to identify the trouble and establish if you need a brand-new board. Next off, get rid of the old board and also its cable connectors.

You can after that proceed to change the circuit card. The replacement process is very easy as well as takes around 10 minutes. A new circuit card will cost about $80. To safeguard your brand-new circuit card from power surges, you can buy a rise protector.

Replacing a photo-eye sensing unit

Changing a photo-eye sensor can be a relatively easy job. Initially, get rid of the sensor from the door and also make sure it is located correctly. If the sensing unit is angled at all, it might not be obtaining the right signal, which could be triggering the blinking lights. If you notice that the photo-eyes run out positioning, you might need to have actually a professional come as well as fix the problem.

The photo-eye sensor contains 2 items that place on the outside of the door tracks as well as toward the floor. The picture eyes will have a small LED light and also must be solid in shade. If the light is blinking, its likely the photo-eye is defective and will require to be changed.

Replacing a primary drive equipment

To replace a garage door opener major drive equipment, begin by eliminating the cap from the chain pulley-block. Next, remove the two screws holding the drive gear to the gear assembly. Currently, you can unfasten the three stress pins. Squeeze them from both sides and then remove them. Then, detach the 3 cords from the garage door opener motor. These wires should be white, red, and blue.

As soon as you have removed the old equipment, set up a new one. Be sure to oil it well. Insert the brand-new equipment right into the shaft, seeing to it to line up the installing holes. See to it the gear and gear assembly are positioned appropriately to ensure smooth procedure. Next, use a hammer as well as a nail to drive a pin right into the new equipment.

Readjusting the set-limit buttons

The initial point you must do if your garage door is not functioning appropriately is to check the set-limit switches. You may require to adjust them so that the door shuts earlier or stops before it gets to the floor. You can check this by looking at your garage doors manual or online.

To change the set-limit buttons, youll require a screwdriver or socket. Adjust the knob clockwise or counterclockwise up until the door moves up as well as quits, or minimizes its distance. To look for correct traveling range, determine the space from the bottom of the garage door to the ground.

Veteran Garage Door Repair – Keller

204 S Key St Ste 105, Keller, TX 76248, United States

817-769-8488

https://veterangaragedoor.com/veteran-garage-door-repair-of-keller-tx/


Garage Door Repair


Garage Door Installation


Garage Door Company


Garage Door Service


Garage Door Opener Repair

Veteran Garage Door Repair

204 S Main St Ste 105
Keller,TX
76248
817-769-8488

Leave a Reply

Your email address will not be published. Required fields are marked *

Back To Top